|
|
|
|
UE Supermaxx Addict!
Offline
Posts: 1,006
Join Date: Feb 2009
Location: Gadsden, Alabama
|
07.15.2009, 10:10 PM
Yea, it can be done with a drill-press, but not with a Dremel. However, I would just use a 1mm thinner bearing, heh.
-Chad
› PM ME IF YOU HAVE THE BELOW:
› VBS, CVDs, GM Single-Speed, OTB, Ultramaxxed, Super6, Strobe, Sprong, CNR Brake, UE Hex, DUH Towers, Predator, Blackbird, GA Blue Screws, HCR F/R Skids & Mutant
|
|
|
|