RC-Monster Forums - View Single Post - brushless 1/5 4wd conversion about to begin! couple questions.

Ryu James · 01:41 PM

in regards to supporting the rear of the motor i would especially with these 2215s cuz the front endbell is screwed on by those tiny 2-56 screws. i really dont like that about the 2215 to be honest. i am pretty sure the older version was a solid closed can with only the rear endbell screwed on. i think this is a better design especially when all the weight of the motor is being mounted off the front endbell. anyway, i wish that Neu just made the 22xx's with a one-piece can with removable rear endbell. like the Tekno Neu 15xx's are.

	(#12)
Ryu James Second place is the first loser! Offline Posts: 899 Join Date: Sep 2008 Location: Utah	07.22.2009, 01:40 PM in regards to supporting the rear of the motor i would especially with these 2215s cuz the front endbell is screwed on by those tiny 2-56 screws. i really dont like that about the 2215 to be honest. i am pretty sure the older version was a solid closed can with only the rear endbell screwed on. i think this is a better design especially when all the weight of the motor is being mounted off the front endbell. anyway, i wish that Neu just made the 22xx's with a one-piece can with removable rear endbell. like the Tekno Neu 15xx's are. Jammin SCRT10 Neu 1512 1y Losi Ten-T SCT conversion Neu 1512 1y Last edited by Ryu James; 07.22.2009 at 01:41 PM.