Quote:
Originally Posted by aqwut
I'm sure the motors will work flawlessly ...
Brian.. Yeah, I kinda figured that about the wires.. the lower KV motors have thinner wires... Also the one that didn't have the bushings had the thickest wires... so maybe, wires were too thick to use bushings... but I just triple shrink wrapped it to be safe..
ZPB... I was replacing all of the cheap motors with either a lehner or a neu.... If lehners were the same price as neu.. I would've bought them... :) but I'm always willing to try new things...
I have yet to try these babies out, Still waitin' for pinion gears .... Mike went away, and so did Dan Fischer... and SDP-SI doesn't work for me... so I'm kinda screwed...
|
Dude, you know I have pushed the piss out of every NEU motor I have owned. I have ran them at RPMS WAY past their spec sheets say. They have been perfect and continue to kick butt in every application I use them in. They are hand built so you will have differences in tolerances...etc. Doesn't effect quality though....