Quote:
Originally Posted by jzemaxx
Dude, you know I have pushed the piss out of every NEU motor I have owned. I have ran them at RPMS WAY past their spec sheets say. They have been perfect and continue to kick butt in every application I use them in. They are hand built so you will have differences in tolerances...etc. Doesn't effect quality though....
|
on a side note, jzemaxx...i have a neu question for you.
I've got an itch to drop a 1515 1.5D in my 8ight roller on 6S.
on 6S i run a max rpm around 55,000rpms with the neu 1Y...after about 10 top speed runs, i'm nearing 180 degrees geared 43/25. do you think i can realistically keep the same gearing with a 2700 motor?
I don't wanna waste my money if it's gonna be too much of a strain on the motor. what do you think?