RC-Monster Forums - View Single Post

J57ltr · 08.06.2009, 12:02 AM

I had to do the same thing with my Faegiao motor because the rear kept popping off and a bad wreck into a storm drain took the front endbell out. I used 4-40 X 3/16 button head screws. And also used the Green Locktite sleeve retaining compound. (it's what they use when they have to replace a sleeve in a lot of LS and Hemi and other engines). I had some laying around and Snelliemin needed to bond a rotor back onto the shaft of one of his motors.

	(#12)
J57ltr RC-Monster Aluminum Offline Posts: 610 Join Date: Feb 2009 Location: Tomball/ Houston Tx.	08.06.2009, 12:02 AM I had to do the same thing with my Faegiao motor because the rear kept popping off and a bad wreck into a storm drain took the front endbell out. I used 4-40 X 3/16 button head screws. And also used the Green Locktite sleeve retaining compound. (it's what they use when they have to replace a sleeve in a lot of LS and Hemi and other engines). I had some laying around and Snelliemin needed to bond a rotor back onto the shaft of one of his motors. Attached Thumbnails The Warnings & Cautions discussed in this manual cant cover all possible conditions/situations. It must be understood that common sense and caution are factors which cant be built into this product.