RC-Monster Forums - View Single Post - Project E-Mini Bike, Using an Outrunner

Metallover · 08.06.2009, 05:06 PM

Using just the servo tester for the throttle, I am pretty sure I am geared too high. Minimum throttle is probably 10 mph. Got a broken pin and some good, long squeals from my motor too. I'll look into gearing down with new gears...

What would I need, 3/16, #35 roller chain? Where do I get sprockets? Could I weld a gear onto the freewheel after cutting the stock plastic pos off?

	(#2)
Metallover RC-Monster Spudgunner Offline Posts: 2,353 Join Date: Apr 2008 Location: South Dakota	08.06.2009, 05:06 PM Using just the servo tester for the throttle, I am pretty sure I am geared too high. Minimum throttle is probably 10 mph. Got a broken pin and some good, long squeals from my motor too. I'll look into gearing down with new gears... What would I need, 3/16, #35 roller chain? Where do I get sprockets? Could I weld a gear onto the freewheel after cutting the stock plastic pos off?