RC-Monster Forums - View Single Post - brushless 1/5 4wd conversion about to begin! couple questions.

Ryu James · 03:24 PM

so i took your advice and Kaz and "grew a set" and drilled and tapped the pinion gear myself. its not perfectly straight but it went a lot better than i expected. here are some pics. you can see how long this gear is. i used 3/16" drill bit and 6mm x 1.00 tap. 6mm set screws go in perfect. fat little stubbies, they are!

	(#4)
Ryu James Second place is the first loser! Offline Posts: 899 Join Date: Sep 2008 Location: Utah	08.08.2009, 03:14 PM so i took your advice and Kaz and "grew a set" and drilled and tapped the pinion gear myself. its not perfectly straight but it went a lot better than i expected. here are some pics. you can see how long this gear is. i used 3/16" drill bit and 6mm x 1.00 tap. 6mm set screws go in perfect. fat little stubbies, they are! Jammin SCRT10 Neu 1512 1y Losi Ten-T SCT conversion Neu 1512 1y Last edited by Ryu James; 08.08.2009 at 03:24 PM.