RC-Monster Forums - View Single Post - brushless 1/5 4wd conversion about to begin! couple questions.

KaztheMinotaur · 07:29 AM

This sucks. They changed their web site. The hub & set screw option isn't offered now. I hope they changed it in the last day or so since you contacted them.

How deep of a hole did you have machined out of the gear? I think it needs to be 4mm deep to have enough of the shaft sticking out the other side to fit on the bearing.

I'm going to a machine shop this morning.

What size set screw did you use in the pinion?

	(#357)
KaztheMinotaur RC-Monster Carbon Fiber Offline Posts: 351 Join Date: Dec 2007 Location: Central PA	08.12.2009, 06:53 AM This sucks. They changed their web site. The hub & set screw option isn't offered now. I hope they changed it in the last day or so since you contacted them. How deep of a hole did you have machined out of the gear? I think it needs to be 4mm deep to have enough of the shaft sticking out the other side to fit on the bearing. I'm going to a machine shop this morning. What size set screw did you use in the pinion? Last edited by KaztheMinotaur; 08.12.2009 at 07:29 AM.