RC-Monster Forums - View Single Post - E Revo Center Diff questions and Opinions

mistercrash · 08.22.2009, 04:49 PM

I went to the store and got a long 6 mm bolt with a lock nut and a couple washers. I put the bolt in the 6 mm hole of the gear for the output shaft and secured the whole thing with the washers and nut. Then I chucked the assembly in the drill press and made it turn fast. I put an angle grinder to the gear and started grinding away at the teeth. A lot of sparks and a lot of noise but it worked.

	(#7)
mistercrash Guelph, Canada, eh! Offline Posts: 1,083 Join Date: Sep 2007 Location: Guelph, Ontario, Canada	08.22.2009, 04:49 PM I went to the store and got a long 6 mm bolt with a lock nut and a couple washers. I put the bolt in the 6 mm hole of the gear for the output shaft and secured the whole thing with the washers and nut. Then I chucked the assembly in the drill press and made it turn fast. I put an angle grinder to the gear and started grinding away at the teeth. A lot of sparks and a lot of noise but it worked. No brain, no headaches.