RC-Monster Forums - View Single Post

magman · 09:20 PM

If I have the same setup.....5k 5s, and one motor spinning 35k rpm and the other at 32k, will there be a noticeable amt. of run time difference....geared the same

set up:1. mmm esc
2200kv ccneu
5s 5k li-po

2. mmm esc
1515 2d Neu
5s 5k

The Neu spins 3k slower than the ccneu....so I am figuring that I should get a couple of extra mins. of run time assuming nothing changes but the motors.....yes, no

	(#1)
magman RC-Monster Dual Brushless Offline Posts: 4,236 Join Date: Dec 2007 Location: Cape Cod, Mass.	Question about motor rpm - 08.23.2009, 09:19 PM If I have the same setup.....5k 5s, and one motor spinning 35k rpm and the other at 32k, will there be a noticeable amt. of run time difference....geared the same set up:1. mmm esc 2200kv ccneu 5s 5k li-po 2. mmm esc 1515 2d Neu 5s 5k The Neu spins 3k slower than the ccneu....so I am figuring that I should get a couple of extra mins. of run time assuming nothing changes but the motors.....yes, no 1. MBX-6 T8 1900KV, RX8 ON 4S 2. MBX-5T 1520, MMM ON 5S 3. MBX-5 ONROAD CONVERSION 1515, MMM ON 5S 4. MRX-3 ON ROAD CONVERSION 1512, MMM ON 6S 5. TEN T 2650 T8, MMP ON 3S Last edited by magman; 08.23.2009 at 09:20 PM.