Quote:
Originally Posted by suicideneil
Screw the front back on, unscrew the rear, then bang the end of the shaft against a hard surface to pop the rear endbell off. You can apply a little blue loctite to the endbell and its screws when you reassemble it, should stay together just fine.
|
Since it is a CC-neu I am not sure that is the best way. The wires connect to the windings in the back. Shoving the rotor into them may not be a good idea (if they are in the way). If you have the front off, pull the rotor out and look in there first, make sure nothing is in the way. If there is, you could use something much smaller to knock the endbell off from the inside. Be sure to keep track of which spacers go where on the shaft.