RC-Monster Forums - View Single Post

GT35R · 10:01 AM

Zetor, mine burned up on its second run too.
I only changed timing to 7.5deg, after reading about the dangers of low punch setting.
Your lucky nothing else burned up when it went off, mine did quite a bit of damage.

It sucks because you soften settings to be careful and nice to your car, not realizing
it could turn it into a time-bomb. I will definately not touch anything other than cutoff
voltage when I get mine back, and will run it without the new body on till I am sure
it will be OK.

Either way, it is NOT acceptable for someone to have to troll forums to pick
up vital info to prevent failure and damage when you are just following the
manufacturers instructions.

	(#12)
GT35R RC-Monster Carbon Fiber Offline Posts: 71 Join Date: Jul 2008	08.26.2009, 10:00 AM Zetor, mine burned up on its second run too. I only changed timing to 7.5deg, after reading about the dangers of low punch setting. Your lucky nothing else burned up when it went off, mine did quite a bit of damage. It sucks because you soften settings to be careful and nice to your car, not realizing it could turn it into a time-bomb. I will definately not touch anything other than cutoff voltage when I get mine back, and will run it without the new body on till I am sure it will be OK. Either way, it is NOT acceptable for someone to have to troll forums to pick up vital info to prevent failure and damage when you are just following the manufacturers instructions. Last edited by GT35R; 08.26.2009 at 10:01 AM.