RC-Monster Forums - View Single Post - brushless 1/5 4wd conversion about to begin! couple questions.

KaztheMinotaur · 08:24 PM

You got that to encase the cable in instead of the tubing that came with the brakes?

I discovered that you don't need to make a new front plate...just flip the stock one over.

The shorter brake rod will have to be cut down a lot. I'm also going to flip the brake servo around to the output shaft wil be to the rear.

	(#7)
KaztheMinotaur RC-Monster Carbon Fiber Offline Posts: 351 Join Date: Dec 2007 Location: Central PA	08.27.2009, 08:09 PM You got that to encase the cable in instead of the tubing that came with the brakes? I discovered that you don't need to make a new front plate...just flip the stock one over. The shorter brake rod will have to be cut down a lot. I'm also going to flip the brake servo around to the output shaft wil be to the rear. Last edited by KaztheMinotaur; 08.27.2009 at 08:24 PM.