RC-Monster Forums - View Single Post

BrianG · 09.08.2009, 03:45 PM

Well, the MM has about the same rating as the HobbyWing 80 as far as the FETs go, so I would just be careful about mesh tightness. Also might help to dial in some punch control (to help reduce the huge instantaneous currents on takeoff) and add a couple extra low-ESR caps to the power leads.

And since the MM has a linear BEC, you will want to disable it (remove the red wire from the throttle cable) and use an external switching BEC.

	(#4)
BrianG RC-Monster Admin Offline Posts: 14,609 Join Date: Nov 2005 Location: Des Moines, IA	09.08.2009, 03:45 PM Well, the MM has about the same rating as the HobbyWing 80 as far as the FETs go, so I would just be careful about mesh tightness. Also might help to dial in some punch control (to help reduce the huge instantaneous currents on takeoff) and add a couple extra low-ESR caps to the power leads. And since the MM has a linear BEC, you will want to disable it (remove the red wire from the throttle cable) and use an external switching BEC.