RC-Monster Forums - View Single Post

scarletboa · 12:57 AM

my KB45-8XL separated the rotor from the shaft, so i ground down the shaft on my KB45-12L 1400kv motor and threw it on my savage. the run lasted about 6 inches as my EZrun 150a smoked itself....the only setting i changed on it was turning the LVC off. i was using a lipo monitor that plugged into the balance lead on the lipos, because the stock setting of 3.0v was too low. i had done it manually as i didn't have the program card at that point and i might have messed something up in the programming in the process of turning the lvc off.

BTW: i was running 2 3s packs in series.

	(#31)
scarletboa RC-Monster Aluminum Offline Posts: 929 Join Date: Mar 2009 Location: Las Vegas NV	09.17.2009, 12:54 AM my KB45-8XL separated the rotor from the shaft, so i ground down the shaft on my KB45-12L 1400kv motor and threw it on my savage. the run lasted about 6 inches as my EZrun 150a smoked itself....the only setting i changed on it was turning the LVC off. i was using a lipo monitor that plugged into the balance lead on the lipos, because the stock setting of 3.0v was too low. i had done it manually as i didn't have the program card at that point and i might have messed something up in the programming in the process of turning the lvc off. BTW: i was running 2 3s packs in series. They say a good mechanic only needs 2 tools - WD40 & Duct tape. If it moves, and its not supposed to, duct tape. If it doesn't move, and its supposed to, WD40. Last edited by scarletboa; 09.17.2009 at 12:57 AM.