View Single Post
New brushless setup for my E-Maxx, would this be good?
Old
  (#1)
Krawlin
Got brushless?
 
Krawlin's Avatar
 
Offline
Posts: 592
Join Date: Aug 2008
Location: Sierra Vista, Arizona
New brushless setup for my E-Maxx, would this be good? - 09.24.2009, 11:13 PM

Since my Medusa 36-80 just snapped it's shaft, I am going to be getting a new motor and batteries. So I am wanting to go with a lower Kv, higher voltage setup. I plan on getting a Tekin 1550Kv truggy motor and 6S.

Here is my main question though

With the Tekin 1550Kv truggy motor and 6S, which of these 2 batteries would be my best bet? Would I even notice a difference? Can I go with the 4000mAh 30C 3S version without noticing any performance difference besides runtime, or will the motor want more than 160amps burst and would I be much better off going with the 5000mAh 30C 3S packs that can put out 200amps burst?

3S 4000mAh 30C/40C
http://www.hobbycity.com/hobbycity/s...idproduct=9510

3S 5000mAh 30C/40C
http://www.hobbycity.com/hobbycity/s...idproduct=9515

Or what about these packs, are they any good?
Flightmax 3S1P 5000mAh 30C
http://www.hobbycity.com/hobbycity/s...idproduct=8587


Monster GT Conversion

Proud Member & Online Recruiter for Team Terribles!
Mugen MBX5-T - Rc-bearings.com


Last edited by Krawlin; 09.24.2009 at 11:26 PM.
  Send a message via Yahoo to Krawlin Send a message via AIM to Krawlin Send a message via MSN to Krawlin  
Reply With Quote