RC-Monster Forums - View Single Post - Are 5.5 bullets big enough? Splicing wire sugestions.

suicideneil · 04:06 PM

Butt joint the wires- just tin them up, offer them up to eachother, then apply the iron et voila, nice solid and straight joint. If this is an MMM v3, then I would do that with those wires that plug into the esc, so you essentially have long leads coming directly from the motor with the 6.5mm bullets on the end that plug into the esc.

You can also buy special butt joint connectors (ebay)- stick the wires in either side then offer up the iron- creates a solid tube that covers & protects the joint.

	(#2)
suicideneil Old Skool Offline Posts: 7,494 Join Date: Feb 2007 Location: Devon, England	09.30.2009, 04:04 PM Butt joint the wires- just tin them up, offer them up to eachother, then apply the iron et voila, nice solid and straight joint. If this is an MMM v3, then I would do that with those wires that plug into the esc, so you essentially have long leads coming directly from the motor with the 6.5mm bullets on the end that plug into the esc. You can also buy special butt joint connectors (ebay)- stick the wires in either side then offer up the iron- creates a solid tube that covers & protects the joint. My Gmaxx thread EMAXX FAQ TUTORIALS USEFUL LINKS MY YOUTUBE Last edited by suicideneil; 09.30.2009 at 04:06 PM.