RC-Monster Forums - View Single Post - AAAARRRRGGGGHHH !!!!!!!!!!Soldering prob.

BrianG · 10.09.2009, 03:38 PM

For best results, you should scrape off what you can, and then also dip the end in that solution I was talking about. Otherwise, the wire is not totally clean and may have a poor solder joint even though it looks good. Also, make sure the inner strands are done as well.

When you are all done, run it carefully monitoring ESC, motor, and battery temps.

	(#7)
BrianG RC-Monster Admin Offline Posts: 14,609 Join Date: Nov 2005 Location: Des Moines, IA	10.09.2009, 03:38 PM For best results, you should scrape off what you can, and then also dip the end in that solution I was talking about. Otherwise, the wire is not totally clean and may have a poor solder joint even though it looks good. Also, make sure the inner strands are done as well. When you are all done, run it carefully monitoring ESC, motor, and battery temps.