RC-Monster Forums - View Single Post - Anybody running Flextek arms with UE diffs? CVD's???

**Anybody running Flextek arms with UE diffs? CVD's??? -** 10.11.2009, 02:13 AM

I'm trying to install a set of flextek arms on my brushless emaxx with UE diffs and cannot find a set of cvd's that will fit. These traxxas cvd's for the emaxx are too short
http://www3.towerhobbies.com/cgi-bin...R+++&search=Go

I also have a set of these MIP's and they are even shorter.
http://www3.towerhobbies.com/cgi-bin...&I=LXDXN7&P=ML

I cannot use the stock sliders with the UE diff cups and would prefer not change the diff outputs. When I stack the Flextek arms next to the stock arms, they are definitely longer by about 5mm.

I am thinking about trying these:
http://www3.towerhobbies.com/cgi-bin...&I=LXXDN2&P=ML

If anybody is running flextek arms with UE diffs, I could sure use some advice.

Thanks for your help.

	(#1)
dwill Guest Posts: n/a	Anybody running Flextek arms with UE diffs? CVD's??? - 10.11.2009, 02:13 AM I'm trying to install a set of flextek arms on my brushless emaxx with UE diffs and cannot find a set of cvd's that will fit. These traxxas cvd's for the emaxx are too short http://www3.towerhobbies.com/cgi-bin...R+++&search=Go I also have a set of these MIP's and they are even shorter. http://www3.towerhobbies.com/cgi-bin...&I=LXDXN7&P=ML I cannot use the stock sliders with the UE diff cups and would prefer not change the diff outputs. When I stack the Flextek arms next to the stock arms, they are definitely longer by about 5mm. I am thinking about trying these: http://www3.towerhobbies.com/cgi-bin...&I=LXXDN2&P=ML If anybody is running flextek arms with UE diffs, I could sure use some advice. Thanks for your help.