RC-Monster Forums - View Single Post

HotnCold · **Mounting pos -** 01.14.2005, 05:46 PM

I mounted my controller in the rear behind the trans in the center of the chassis ( forward to back mounted not side to side ) that way the motor wires are not too long of a stretch to the speed controller - and my bec i wrapped in black tape ( to keep out dust and dirt ) and mounted in the front on my steering servo with double sided tape and a small zip tie - ( not to tight though )

	(#2)
HotnCold RC-Monster Admin Offline Posts: 1,065 Join Date: Dec 2004 Location: RC-Monster Store....Where else?	Mounting pos - 01.14.2005, 05:46 PM I mounted my controller in the rear behind the trans in the center of the chassis ( forward to back mounted not side to side ) that way the motor wires are not too long of a stretch to the speed controller - and my bec i wrapped in black tape ( to keep out dust and dirt ) and mounted in the front on my steering servo with double sided tape and a small zip tie - ( not to tight though ) Hows that "Hope and Change" working out for Ya???