RC-Monster Forums - View Single Post

BrianG · 10.19.2009, 11:16 AM

Yes, this is definitely possible; just use a Y cable. However, getting the servo to work perfectly with the ESC might be a bit of a PITA. You can probably fiddle with the mechanicals to allow it to work. But, if your radio has channel mixing and is a 3 channel radio, you can slave ch3 to the throttle channel. Use the throttle channel to the ESC and ch3 to the servo. This allows them to be controlled with the throttle trigger, yet each has their own endpoints, travel adjustment, etc.

	(#3)
BrianG RC-Monster Admin Offline Posts: 14,609 Join Date: Nov 2005 Location: Des Moines, IA	10.19.2009, 11:16 AM Yes, this is definitely possible; just use a Y cable. However, getting the servo to work perfectly with the ESC might be a bit of a PITA. You can probably fiddle with the mechanicals to allow it to work. But, if your radio has channel mixing and is a 3 channel radio, you can slave ch3 to the throttle channel. Use the throttle channel to the ESC and ch3 to the servo. This allows them to be controlled with the throttle trigger, yet each has their own endpoints, travel adjustment, etc.