RC-Monster Forums - View Single Post

Metallover · 10.25.2009, 09:51 PM

An hour and a half down. One stator clean. First 6 teeth took about 15 minutes. Next two teeth took about 45 minutes. Last tooth took 45 minutes and some serious concentration and anger management. There was some sort of epoxy or glue on the one tooth. That stator suffered a little damage, but I think it'll be ok.

I'll start winding probably tomorrow with the 26awg wire. Turns out 26awg is probably the exact size the original windings used. I hope to be around the 1000-1200kv range.

Here are some pics

And I found I was geared for 75mph with the old 2300kv.

	(#54)
Metallover RC-Monster Spudgunner Offline Posts: 2,353 Join Date: Apr 2008 Location: South Dakota	10.25.2009, 09:51 PM An hour and a half down. One stator clean. First 6 teeth took about 15 minutes. Next two teeth took about 45 minutes. Last tooth took 45 minutes and some serious concentration and anger management. There was some sort of epoxy or glue on the one tooth. That stator suffered a little damage, but I think it'll be ok. I'll start winding probably tomorrow with the 26awg wire. Turns out 26awg is probably the exact size the original windings used. I hope to be around the 1000-1200kv range. Here are some pics And I found I was geared for 75mph with the old 2300kv.