RC-Monster Forums - View Single Post - 2200kv Torq motor, how do I remove the rear bearing?

Pdelcast · 11.10.2009, 12:21 PM

And you can get the bearing number right off the bearing too -- can even read it in your post. :)

That is an NMB (nippon miniature bearing) 625ZZ ABEC bearing. Chrome steel, double shield.

Manufacturer's web site:

http://www.nmbtc.com/bearings/

5mm x 16mm x 5mm

And I agree - -the bearing looks fine. Doesn't look like there is any issue.

It's both press fit and glued in place.

	(#7)
Pdelcast RC-Monster Titanium Offline Posts: 1,697 Join Date: Mar 2008	11.10.2009, 12:21 PM And you can get the bearing number right off the bearing too -- can even read it in your post. :) That is an NMB (nippon miniature bearing) 625ZZ ABEC bearing. Chrome steel, double shield. Manufacturer's web site: http://www.nmbtc.com/bearings/ 5mm x 16mm x 5mm And I agree - -the bearing looks fine. Doesn't look like there is any issue. It's both press fit and glued in place. Patrick del Castillo President, Principle Engineer Castle Creations