Ok Guys i finally got a chance to run my EREVO on 6s. My setup was CC 2200Kv setup, Hyperion G3 3s 5500 bats and geared 18/62. I was running on grass and dirt and it ran fine for about 15mins. I was checking temps regularly and at this point it was motor 140f-160f and speedy about 140f. Than my truck just stopped. I went over pulled the shell off and checked temps again, all good plugged it back in turned it on and it went about 3 meters and puff one MMM turned to ash
again
Luckily i had my data logger on at the time and recorded the whole run. The only high point was for 142A but at 3mins in. Nothing out of the ordinary after that.
What the hell is going on. I think i must passion fingers.