RC-Monster Forums - View Single Post

MetalMan · 12:20 PM

48amps constant should be enough.

When too many amps are pulled from a Lipo, then its voltage will drop below 3volts/cell. This is where a LVC would be used, to stop the cells from dropping below 3volts. For some Lipos, at their maximum continuous amp draw, they will overheat when discharged continuously at that rate (like TP Lipos).

Maxamps isn't a bad company, and they have some of the best customer service. Those particular 4000mah cells perform rather well, too.

	(#2)
MetalMan RC-Monster Mod Offline Posts: 5,297 Join Date: Mar 2005 Location: SoCal	01.30.2006, 11:57 AM 48amps constant should be enough. When too many amps are pulled from a Lipo, then its voltage will drop below 3volts/cell. This is where a LVC would be used, to stop the cells from dropping below 3volts. For some Lipos, at their maximum continuous amp draw, they will overheat when discharged continuously at that rate (like TP Lipos). Maxamps isn't a bad company, and they have some of the best customer service. Those particular 4000mah cells perform rather well, too. SH Z-Car, Custom Crawler, 8s Savage, 12s XTM XLB 1/7 buggy, 4wd 4-link rear/IFS Pro4 truck, Custom Hyper 10 Short Course, Belt-Drive Mammoth ST 1/8 truggy, 4s 17.5 MM Pro HPI Blitz Last edited by MetalMan; 01.30.2006 at 12:20 PM.