RC-Monster Forums - View Single Post

Nard Cox · 11.29.2009, 06:29 PM

I will check the 'fases' first, but need a battery for that.

With motor connectors you mean the motor stiff wire to my other wire (which was a pain in the ass to solder since the solder didn't stick properly to the original wire) or the other wire to the connectors (which go into the Esc) ?

Any good way to take the current heat shrink off without damaging the underlying wire, or just be very careful with a ''stanley''.

	(#18)
Nard Cox n00b Offline Posts: 519 Join Date: Apr 2009 Location: The Netherlands	11.29.2009, 06:29 PM I will check the 'fases' first, but need a battery for that. With motor connectors you mean the motor stiff wire to my other wire (which was a pain in the ass to solder since the solder didn't stick properly to the original wire) or the other wire to the connectors (which go into the Esc) ? Any good way to take the current heat shrink off without damaging the underlying wire, or just be very careful with a ''stanley''.