[lincpimp]

Make sure your lipos are around 90-100f before the run.

I have a 4500 6s 30c fp lipo, and ran my muggy last week with it. It had been sitting in the lipo drawer for a few months, fully charged. Performance was terrible, not even getting 25mph. It was stone cold (maybe 50f) so I stuck it in front of a small electric fire for a few mins, got the pack up to 85 or so. Then I figured I would check to see if it was charged fully. 610i put about 70mah back in so it was very close to full. Put it back in the muggy and performance was better. So I did alot of stop and accel to warm the pack up a bit. After a few mins I was wheeling down the street and doing 45mph.

Conclusion, lipo temps matter. Some lipos like to be warm (enerland 30c run warmer than the 25c do) and I can imagine that all lipos will benefit from being around 85-90f before the run.

I thought the "Redshit" was funny too... Just cause I do the same thing when I am typing and do not even notice.

So since I figured this out, can I have a job at Fat Kid Engineering? Sounds like a great place, completely lacking and public correctnees!!!!