Im Basically remaking the large motor plate and braces as one peice, from 1/4in aluminum...
Winter sucks.. snapped a drill bit, Got that out, tried to thread a screw in, snapped the head off, drilled it out, then broke my m3 tap in the hole... cant get it out, so i ground it flush..
But. I mounted the transmission. roll bar, center driveshafts, rear toe links.
Had to improvise as I had no transmission output cups. Used 1mmthick aluminum sheet metal. Made a sleve for the transmission output shaft to fit the differential pinion drive cups..
It can sit on its 4 wheels by itself now!
