RC-Monster Forums - View Single Post - Flux drive cup o-rings

Finnster · 12.17.2009, 09:46 AM

I might of had them at first, but I don't remem.

Basically they are to cushion the driveline and limit the in/out travel of the dogbone.
The sus conv kit uses smaller axels w/ smaller ends and drive cups, so the needed o-ring would be smaller.

I don't have them now, and I don't really care. Probably reduces pin wear some, but, eh. Too fiddly to worry about.

	(#2)
Finnster KillaHurtz Offline Posts: 2,958 Join Date: Apr 2006 Location: Bucks Co, PA	12.17.2009, 09:46 AM I might of had them at first, but I don't remem. Basically they are to cushion the driveline and limit the in/out travel of the dogbone. The sus conv kit uses smaller axels w/ smaller ends and drive cups, so the needed o-ring would be smaller. I don't have them now, and I don't really care. Probably reduces pin wear some, but, eh. Too fiddly to worry about.