i personally have a CNCmasters baron. Got it for christmas last year :) Cost about 13k after all the little doodads and a good set of tooling.
it'll hold
+/- 0.00025 per inch
+/- 0.003" in 12"
with resolution in the ten thousandths.
I'm running soldiworks 2009 with a cam software.
Mills really good for projects that you arnt in a hurry to have done. With the spindle speed maxing out at 1500 RPM, really cuts down your feed rate.
also have the basic shop equipment.


i do have access to the grand baby of all babies....the HAAS 50 series Tapper and HAAS 5-axis VMC. they are sexy and powerfull machines