RC-Monster Forums - View Single Post

sikeston34m · **Finally got me an Eagletree Data Logger! -** 12.26.2009, 10:43 PM

Well I finally got me an Eagletree Data Logger!

I made a run with my E Revo with Medusa Setup and my V2 Monster finally bit the dust!

So it was time to change the entire setup around.

This setup is one of the old HV4400 Maxx sensored Motors upgraded with the Sintered Rotor w/5mm shaft.

I have no idea what top speed this is geared for. LOL

It is geared 14/52 using Mod 1 gears.

ESC of choice is the MM Pro! It does have some power handling ability

Power Supply is a pair of Turnigy 4S 20C 4000mah wired parallel.

Just a few short bursts on the graph. It's dark here, but I'll get some good graphs tomorrow.

Ever seen a 4S setup hold 3.91 volts per cell under a 108 amp Load?

There is MUCH experimenting to be done!

Check this out!

	(#1)
sikeston34m RC-Monster Brushless Offline Posts: 2,085 Join Date: Sep 2007	Finally got me an Eagletree Data Logger! - 12.26.2009, 10:43 PM Well I finally got me an Eagletree Data Logger! I made a run with my E Revo with Medusa Setup and my V2 Monster finally bit the dust! So it was time to change the entire setup around. This setup is one of the old HV4400 Maxx sensored Motors upgraded with the Sintered Rotor w/5mm shaft. I have no idea what top speed this is geared for. LOL It is geared 14/52 using Mod 1 gears. ESC of choice is the MM Pro! It does have some power handling ability Power Supply is a pair of Turnigy 4S 20C 4000mah wired parallel. Just a few short bursts on the graph. It's dark here, but I'll get some good graphs tomorrow. Ever seen a 4S setup hold 3.91 volts per cell under a 108 amp Load? There is MUCH experimenting to be done! Check this out!