RC-Monster Forums - View Single Post

Madsen66 · **Thanks for the nice words -** 01.10.2010, 06:29 PM

I have thought about removing the center gear wheel
but then you have to use bigger pinon and less spun gear Due to space
And no, I do not have a CNC, it is the job I have access to a cnc
and 24 hours is not enough hours :-) to do something for other people I am sorry
If you lay the tranny down on its side and mount the motor flat on the chassis
disappear my idea that everything must be installed in the center to keep the car in balance
engine in the center and 2 power pack one in each side

	(#14)
Madsen66 RC-Monster Stock Offline Posts: 8 Join Date: May 2009 Location: Danmark	Thanks for the nice words - 01.10.2010, 06:29 PM I have thought about removing the center gear wheel but then you have to use bigger pinon and less spun gear Due to space And no, I do not have a CNC, it is the job I have access to a cnc and 24 hours is not enough hours :-) to do something for other people I am sorry If you lay the tranny down on its side and mount the motor flat on the chassis disappear my idea that everything must be installed in the center to keep the car in balance engine in the center and 2 power pack one in each side