RC-Monster Forums - View Single Post - New motor for e-jato

BrianG · 01.15.2010, 05:53 PM

I don't have that fine sandpaper, but I used some steel wool. I made sure to cover all openings of course. Took a bit, but works now. There were no high spots; seemed like the whole shaft was just a hair larger in diameter. I should have measured the shafts of the VXL and CC4600 before this, but oh well.

	(#21)
BrianG RC-Monster Admin Offline Posts: 14,609 Join Date: Nov 2005 Location: Des Moines, IA	01.15.2010, 05:53 PM I don't have that fine sandpaper, but I used some steel wool. I made sure to cover all openings of course. Took a bit, but works now. There were no high spots; seemed like the whole shaft was just a hair larger in diameter. I should have measured the shafts of the VXL and CC4600 before this, but oh well.