[kraegar]

Got my plastic today, going to go grab some thin metal rod to form a prototype out of, and some wood to form molds out of. Made some good plans for how to do that.

Got the slash stripped down to where I want.

Doing some rough designs on paper already, I think this will work out nicely.

Did a test run with the plastic, bending the abs rod is simple enough. Going with the .250" abs (also got .375, that's a bit too thick) and some delrin (test bends on that aren't done yet, but I don't see it working as well).

Got a few different thicknesses of plastic sheet, too, for the body.

Tony