RC-Monster Forums - View Single Post

joeling · 02.06.2006, 10:27 PM

Dear Metalman,

I took courage & opened up the heatshrink. Well, there is a circuit board where the cells attach to & it will be easy to solder additional wires for use as taps for balancing purpose. I took a reading of the cells & they were 3.69V & 3.35V respectively. What a big difference ! :026: :002: To the best of my knowledge, I have run this set of 2S lipo less than 5 times ! Now I am scared to run any of my cells because of this. I will have to solder some taps & charge the cells one at a time while I wait for the balancer & associated wiring to arrive.

Regards,
Joe Ling

	(#5)
joeling RC-Monster Carbon Fiber Offline Posts: 463 Join Date: Aug 2005 Location: Malaysia	02.06.2006, 10:27 PM Dear Metalman, I took courage & opened up the heatshrink. Well, there is a circuit board where the cells attach to & it will be easy to solder additional wires for use as taps for balancing purpose. I took a reading of the cells & they were 3.69V & 3.35V respectively. What a big difference ! :026: :002: To the best of my knowledge, I have run this set of 2S lipo less than 5 times ! Now I am scared to run any of my cells because of this. I will have to solder some taps & charge the cells one at a time while I wait for the balancer & associated wiring to arrive. Regards, Joe Ling