RC-Monster Forums - View Single Post - Gearing question... Everything running too hot

ozdave · 07:56 AM

well i finally got my truck out again after way too long! Have moved back to Brisbane, Australia from London and well its all running way too hot in the summer here! Motor, esc and batts are overheating... but the batteries are the hottest and then the esc. Ideally i'd love to keep it the same speed and get it running cooler, but i dont think thats an option for me.

So i figure its overgeared and drawing too much current therefore I'm looking to change the gearing to try cool it all down. Due to my current setup i cant change the pinion any smaller as there is no clearance to move the motor closer. So.. was thinking about going bigger on the spur. will this have the same effect? Also thinking of going 1 tooth bigger on the the pinion as well. What effect will this have? just to slow the truck down more?

Currently its geared 51/16. Thoughts? Have i got it all wrong?

Also I currently have a Ofna 51T Spur. does anyone know where I can just get a bigger (say 52T) nylon gear to fit onto the ofna centre?

Oh motor is a FEIGAO 540C 8XL and Warrior 9920 controller

Thanks!

	(#1)
ozdave RC-Monster Carbon Fiber Offline Posts: 52 Join Date: Mar 2007	Gearing question... Everything running too hot - 02.10.2010, 07:42 AM well i finally got my truck out again after way too long! Have moved back to Brisbane, Australia from London and well its all running way too hot in the summer here! Motor, esc and batts are overheating... but the batteries are the hottest and then the esc. Ideally i'd love to keep it the same speed and get it running cooler, but i dont think thats an option for me. So i figure its overgeared and drawing too much current therefore I'm looking to change the gearing to try cool it all down. Due to my current setup i cant change the pinion any smaller as there is no clearance to move the motor closer. So.. was thinking about going bigger on the spur. will this have the same effect? Also thinking of going 1 tooth bigger on the the pinion as well. What effect will this have? just to slow the truck down more? Currently its geared 51/16. Thoughts? Have i got it all wrong? Also I currently have a Ofna 51T Spur. does anyone know where I can just get a bigger (say 52T) nylon gear to fit onto the ofna centre? Oh motor is a FEIGAO 540C 8XL and Warrior 9920 controller Thanks! Last edited by ozdave; 02.10.2010 at 07:56 AM.