Quote:
Originally Posted by zeropointbug
Nope not yet, I usually shut down completely from R/C come fall and then get re-inspired in late winter, such as now.
Luc, supporting the outrunner housing is a challenge as well, as there is alot more leverage on it that if you would just use it normally, roughly twice it would seem? Just trying to imagine the forces.
|
Scorpion answered this problem with their press fit endbell bearing. On the large end of the motor, by the mount.
Three bearings to support the diff/endbell. A large bearing on the mount side, one at the center to the shaft, then the last bearing would support the end of the diff.