RC-Monster Forums - View Single Post - Slowing down a stock setup (titans in series??)

MetalMan · 10:23 AM

The EVX runs its motors in parallel on the circuit board. You could remove two of the motor wires. What I did on mine is take 12ga. wire and split the ends to go into both wire holes on the circuit board, since 12ga. is too large in diameter to fit into one 14ga. wire hole. (I hope this makes sense)
Then from the two 12ga. wires, you could have each one go to each motor, then put a wire between the motors to connect them in series.

	(#2)
MetalMan RC-Monster Mod Offline Posts: 5,297 Join Date: Mar 2005 Location: SoCal	02.13.2006, 10:21 AM The EVX runs its motors in parallel on the circuit board. You could remove two of the motor wires. What I did on mine is take 12ga. wire and split the ends to go into both wire holes on the circuit board, since 12ga. is too large in diameter to fit into one 14ga. wire hole. (I hope this makes sense) Then from the two 12ga. wires, you could have each one go to each motor, then put a wire between the motors to connect them in series. SH Z-Car, Custom Crawler, 8s Savage, 12s XTM XLB 1/7 buggy, 4wd 4-link rear/IFS Pro4 truck, Custom Hyper 10 Short Course, Belt-Drive Mammoth ST 1/8 truggy, 4s 17.5 MM Pro HPI Blitz Last edited by MetalMan; 02.13.2006 at 10:23 AM.