RC-Monster Forums - View Single Post - Losi Ten-T Conversion

RC-Monster Mike · 01:28 PM

The spurs are mod.8 - basically metric 32p. IIRC, I used a 16t pinion on the 52t spur with the 1900Kv Tekin setup on 4s(truck hasn't yet returned from the RCX SHOW). We have a full range of the mod.8 pinions(12T - 26T) and prefer the higher resolution and efficiency of the mod.8 vs. the mod1 gears. Mod.8 is plenty strong, too.
Also, the motor mount and lower plate/brace is designed to accomodate the included spur. Anything larger would require spacers and may also cause interference with the steering servo/rx box - everything is pretty snug on this little gem. :)

	(#251)
RC-Monster Mike Site Owner Offline Posts: 4,915 Join Date: Nov 2004 Location: PA	03.30.2010, 01:27 PM The spurs are mod.8 - basically metric 32p. IIRC, I used a 16t pinion on the 52t spur with the 1900Kv Tekin setup on 4s(truck hasn't yet returned from the RCX SHOW). We have a full range of the mod.8 pinions(12T - 26T) and prefer the higher resolution and efficiency of the mod.8 vs. the mod1 gears. Mod.8 is plenty strong, too. Also, the motor mount and lower plate/brace is designed to accomodate the included spur. Anything larger would require spacers and may also cause interference with the steering servo/rx box - everything is pretty snug on this little gem. :) Last edited by RC-Monster Mike; 03.30.2010 at 01:28 PM.