RC-Monster Forums - View Single Post - A project i am planning for this or next year, would like Novak's opinion

crazyjr · 09:31 PM

As i said, I'm just asking if there is any design area that would prevent running 25 volts through a Novak motor. I know they are designed for 2s (possibly 3s) operation, I am not figuring much over 45 amps going through the motor, The lehner only gets 40 amp peaks on 5s

I am wondering if novaktwo doesn't want to answer, in case we want to blame someone. I can assure him, I take responsibility if i try this and it fails. Just want to know if there is something, built in or in the design, that would not allow it to run on 6s lipo

	(#3)
crazyjr RC-Monster Dual Brushless Offline Posts: 3,794 Join Date: May 2005 Location: georgia	04.28.2010, 09:25 PM As i said, I'm just asking if there is any design area that would prevent running 25 volts through a Novak motor. I know they are designed for 2s (possibly 3s) operation, I am not figuring much over 45 amps going through the motor, The lehner only gets 40 amp peaks on 5s I am wondering if novaktwo doesn't want to answer, in case we want to blame someone. I can assure him, I take responsibility if i try this and it fails. Just want to know if there is something, built in or in the design, that would not allow it to run on 6s lipo Work because i gotta, play because i wanna People here hate Nitro, I love it. I start it, run it about 50 ft from me and it dies, I go after it. Perfect exercise Last edited by crazyjr; 04.28.2010 at 09:31 PM.