RC-Monster Forums - View Single Post

Serum · 10:43 AM

Titanium is a PITA to work on..

I've got some titanium rods, but it's so darn tough.. with a simple rasp, it's almost impossible to get some off. you need a high speed dremel to machine it a bit.

You need a drill press to make holes in it, it's a disaster, no wonder titanium parts are that expensive

	(#4)
Serum RC-Monster Admin Offline Posts: 10,480 Join Date: Feb 2005	02.18.2006, 10:39 AM Titanium is a PITA to work on.. I've got some titanium rods, but it's so darn tough.. with a simple rasp, it's almost impossible to get some off. you need a high speed dremel to machine it a bit. You need a drill press to make holes in it, it's a disaster, no wonder titanium parts are that expensive Last edited by Serum; 02.18.2006 at 10:43 AM.