Quote:
Originally Posted by Ryu James
i have carbide bits for my dremel but my machinist did not have carbide bits. i looked online and found several different types for CNCs. was not sure what type to buy. any recommendations on carbide bits?
|
Maybe you can have him look at the bits below built specifically for carbon fiber:
"Milling cutter for carbon fiber"
"Solid Carbide Carbon Graphite Cutter"
Base on the designs above, I think you will have to look for a tool that really grinds away the material to leave a clean 'cut'... I am also assuming that these tools are spon at a high rate too.
If I find any more, I will post them.
Alien