RC-Monster Forums - View Single Post - I just won a like-new UE Lightning Chassis for $416!!!

Chadworkz · 12:36 PM

You can run the 8mm CVDs in the 15mm knuckles with the use of 8x15x5 bearings. They are a little bit difficult to find, but they are out there...and you can run them until you find a set of 16mm knuckles. Or, some people have successfully milled the knuckles to 16mm, so if you have a local machine shop, you could go that route. Maybe Mike might do it for you, as I am sure he can do it right.

	(#89)
Chadworkz UE Supermaxx Addict! Offline Posts: 1,006 Join Date: Feb 2009 Location: Gadsden, Alabama	05.25.2010, 12:33 PM You can run the 8mm CVDs in the 15mm knuckles with the use of 8x15x5 bearings. They are a little bit difficult to find, but they are out there...and you can run them until you find a set of 16mm knuckles. Or, some people have successfully milled the knuckles to 16mm, so if you have a local machine shop, you could go that route. Maybe Mike might do it for you, as I am sure he can do it right. -Chad › PM ME IF YOU HAVE THE BELOW: › VBS, CVDs, GM Single-Speed, OTB, Ultramaxxed, Super6, Strobe, Sprong, CNR Brake, UE Hex, DUH Towers, Predator, Blackbird, GA Blue Screws, HCR F/R Skids & Mutant Last edited by Chadworkz; 05.25.2010 at 12:36 PM.