RC-Monster Forums - View Single Post - Losi LST1.5 - Brushless LST2: Bigmaxximum, Quark 125B, 5S

05.30.2010, 12:09 PM

Motor mount and the LiPo tray (the three smallest parts will be place don the sides of the tray to secure the LiPo). It’s mount out of aluminium 6065 and 7075. Especaially the making of the LiPo tray consumed a lot of time.

The complete LiPo tray.

LiPo tray from below.

Unfortunately I didn’t make any pictures of the ESC Mount. All scews used a M3 or M4, zinc as well as regular.
So lets now go to the complete LST1.5...

The powerhouse of this monster: the Plettenberg Bigmaxximum 2300kv brushless motor.

Pletti’s assistant: the Quark Airmaster 125B, enough for 125A continuous and 300A peak.

The Flightmax Flightmax 5S 5000mAh 40C LiPo in the home made, solid, perfect fit LiPo tray.

The enourmous 8mm bullet connectors.

The CC UBEC to assist the Quark in making sure the receiver gets 5V.

Five extra 470uF capacitors were soldered to the ESC.

The on/off switch off the Quark (yes there’s a picture of everything)

	(#2)
Byte Guest Posts: n/a	05.30.2010, 12:09 PM Motor mount and the LiPo tray (the three smallest parts will be place don the sides of the tray to secure the LiPo). It’s mount out of aluminium 6065 and 7075. Especaially the making of the LiPo tray consumed a lot of time. The complete LiPo tray. LiPo tray from below. Unfortunately I didn’t make any pictures of the ESC Mount. All scews used a M3 or M4, zinc as well as regular. So lets now go to the complete LST1.5... The powerhouse of this monster: the Plettenberg Bigmaxximum 2300kv brushless motor. Pletti’s assistant: the Quark Airmaster 125B, enough for 125A continuous and 300A peak. The Flightmax Flightmax 5S 5000mAh 40C LiPo in the home made, solid, perfect fit LiPo tray. The enourmous 8mm bullet connectors. The CC UBEC to assist the Quark in making sure the receiver gets 5V. Five extra 470uF capacitors were soldered to the ESC. The on/off switch off the Quark (yes there’s a picture of everything)