RC-Monster Forums - View Single Post

Kcaz25 · 04:05 PM

Yeah that how I'll do it. I'm buying some very short Nova towers from Chad then I'm going to bolt and space them together to the CF then let the dremel do the rest just like MisterCrash showed us! Great. Oh and of course I'll put wing mount holes in.

I am doing a total rebuild of the truck and I went to open my CCNeu for the first time to inspect the bearing and I found this stuff on the ends of the rotor. Umm look...VVV what is it? Its good right?

Here is what it replaced. Novak HVMAXX rotor.

Its solid. Temps are always under 150. Its been a great performer for a year and a half. Running it at least twice a every week with the exception of a few months where I was really busy or away. It pushes this truck around like a rag doll of course, no surprise. It is the motor of choice since its apperance.

Also how do I remove the bearing on the pinion side?

	(#14)
Kcaz25 RC-Monster Titanium Offline Posts: 1,419 Join Date: Dec 2008 Location: Louisville, KY	06.01.2010, 04:03 PM Yeah that how I'll do it. I'm buying some very short Nova towers from Chad then I'm going to bolt and space them together to the CF then let the dremel do the rest just like MisterCrash showed us! Great. Oh and of course I'll put wing mount holes in. I am doing a total rebuild of the truck and I went to open my CCNeu for the first time to inspect the bearing and I found this stuff on the ends of the rotor. Umm look...VVV what is it? Its good right? Here is what it replaced. Novak HVMAXX rotor. Its solid. Temps are always under 150. Its been a great performer for a year and a half. Running it at least twice a every week with the exception of a few months where I was really busy or away. It pushes this truck around like a rag doll of course, no surprise. It is the motor of choice since its apperance. Also how do I remove the bearing on the pinion side? Last edited by Kcaz25; 06.01.2010 at 04:05 PM.