|
|
|
|
UE Supermaxx Addict!
Offline
Posts: 1,006
Join Date: Feb 2009
Location: Gadsden, Alabama
|
06.10.2010, 09:12 AM
Ok, so the pot on the XMODS board is not like a standard pot, or even the pot on a Mini-Z board, so I have another idea...
...since I can't just unhook the wires from the micro-servo motor and hook them to the servo-motor in the XMODS, because that takes the pot out of the loop, I thought I could keep the wires attached to the motor in the micro-servo, and then just run parallel wires to the servo in the XMODS...that powers the servo-motor in the XMODS, and keeps the pot in the micro-servo in the loop.
Do you think this will work?
-Chad
› PM ME IF YOU HAVE THE BELOW:
› VBS, CVDs, GM Single-Speed, OTB, Ultramaxxed, Super6, Strobe, Sprong, CNR Brake, UE Hex, DUH Towers, Predator, Blackbird, GA Blue Screws, HCR F/R Skids & Mutant
|
|
|
|