RC-Monster Forums - View Single Post

jpoprock · 06.14.2010, 01:13 PM

Ray... Do you trace the template over the aluminum by hand, with that knife shown in the picture, then put it on your router? Do you use the same type of bit (Tungston) that you use for cutting your CF? I'm just asking if that router table method is the same for aluminum as it is for CF. Thanks!

	(#267)
jpoprock "Don't act like you're not impressed." Offline Posts: 358 Join Date: Oct 2008 Location: Central Indiana	06.14.2010, 01:13 PM Ray... Do you trace the template over the aluminum by hand, with that knife shown in the picture, then put it on your router? Do you use the same type of bit (Tungston) that you use for cutting your CF? I'm just asking if that router table method is the same for aluminum as it is for CF. Thanks! ERBE: RCM 1/8 Hybrid Diffs, NEU 1515/2.5d/S MMM, 6S, Losi E-XXL CUSTOM, Neu1515 2.5d, MMM, 6s E-SLAYVO PRO ERevo Chassis w/ Pro 3.3 parts, NEU 1512, MMM, 4S.