RC-Monster Forums - View Single Post

rschoi_75 · 01:12 PM

I didn't know exactly what forum to ask this, so I guess I'll ask here.

What do you guys do when you've stripped the threading on an aluminum hole? I know I can jb weld the hole, and then re-tap and re-thread.... but is there an alternative that does not require JB?

	(#1)
rschoi_75 Certified Spaceball Offline Posts: 675 Join Date: Jun 2007 Location: CA	question about stripped threads - 06.20.2010, 12:40 PM I didn't know exactly what forum to ask this, so I guess I'll ask here. What do you guys do when you've stripped the threading on an aluminum hole? I know I can jb weld the hole, and then re-tap and re-thread.... but is there an alternative that does not require JB? There's two sides to every schwartz, he got the up side and I got the down side. rcm xt8 rcm xb8 rcm crt.5 Last edited by rschoi_75; 06.20.2010 at 01:12 PM.