RC-Monster Forums - View Single Post - Possible to use the plastic 8ight-e spur on a nitro conversion?

scarletboa · 06.21.2010, 12:44 AM

i use a dremel or sandpaper to grind the gear a little thinner while it is spinning. if it won't spin at all, just use sandpaper until it will. then, grind it while spinning with a dremel to get a tiny bit of clearance. that is what i did with my matrix and my crt x2.

	(#7)
scarletboa RC-Monster Aluminum Offline Posts: 929 Join Date: Mar 2009 Location: Las Vegas NV	06.21.2010, 12:44 AM i use a dremel or sandpaper to grind the gear a little thinner while it is spinning. if it won't spin at all, just use sandpaper until it will. then, grind it while spinning with a dremel to get a tiny bit of clearance. that is what i did with my matrix and my crt x2. They say a good mechanic only needs 2 tools - WD40 & Duct tape. If it moves, and its not supposed to, duct tape. If it doesn't move, and its supposed to, WD40.