RC-Monster Forums - View Single Post

RC-Monster Mike · 03.19.2005, 02:58 PM

Evan, I was not able to pull full throttle due to lack of traction. I was over half throttle, though and had to let off in an attempt to keep it fairly straight.
Norbert,
I was using a Lehner basicxl 2400 motor and 18.5 volt (5s) LiPo batteries. What driveshaft are you breaking? A wheel shaft (diff to wheel)? I was actually using the stock plastic sliders on the e-maxx we are speaking of. My truck is just under 8 pounds RTR, though.

	(#16)
RC-Monster Mike Site Owner Offline Posts: 4,915 Join Date: Nov 2004 Location: PA	03.19.2005, 02:58 PM Evan, I was not able to pull full throttle due to lack of traction. I was over half throttle, though and had to let off in an attempt to keep it fairly straight. Norbert, I was using a Lehner basicxl 2400 motor and 18.5 volt (5s) LiPo batteries. What driveshaft are you breaking? A wheel shaft (diff to wheel)? I was actually using the stock plastic sliders on the e-maxx we are speaking of. My truck is just under 8 pounds RTR, though.